Fine Adjustment

The screen drop height has been preset before delivery. If you need to alter
the adjustments of the up or down function of the screen, follow these steps.

A. The adjustment alternatives can be found
on the side opposite the motor. (to the
right of the motor)

B. You will need a screw driver to turn
the switch.

C. When the black drop is too long, turn the
"down stop" limit switch with the screwdriver
counter clockwise to decrease the length of the black drop,
then run the screen down to test the stop position. Repeat this process
until the screen is in the desired position.

D. When the black drop is too short, turn the "up
stop" limit switch with a screw driver clockwise
to increase the amount of up travel, then run
the screen up to test the stop position.
Repeat this until the screen stops in the desired
position.

Caution:
The adjustment of the black drop has already been set by the manufacturer
and should normally not require re-adjustment.
The projection screen canvas could be severely damaged if it can over extend
too far or re-tract too short
If possible, please contact you local retailer for professional support. Your
warranty might expire if you do not follow the instructions described in the
manual. Use at your own discretion.

Maintaining and Cleaning

The screen housing can be cleaned when the screen is unpluged. Do not use
a water towel or wash it directly with water.

The screen canvas should be cleaned with a dry towel. Do not touch the screen
sureface directly to avoid damageing/scratching the surface.

Never hand anything on the screen houseing as this may over burden the
screen.

Turn off electricity and retract the canvas when not in use.